We track and analyze a variety of metrics including customer satisfaction rate and referral rate, then take some measures and thus continually exceed customers' expectations. KLS molex connector-board to board connector-electrical connector types Over the years, we have been striving to deliver exceptional KLS through operational excellence and continual improvement to the global customers. An increasing number of customers pay attention to us and intend to cooperate with us. With that, the brand reputation of KLS also has been greatly enhanced. Since launched, our products have achieved an increasing sales growth and won more and more favors from customers. Many GPS and other modules bought from China comes with robot cable with hard outer sheath.Molex connector-board to board connector-electrical connector types With powerful economic advantages and manufacturing capabilities, we are capable of designing and manufacturing exquisite products which are highly praised by our customers.AUAV (PixRacer) supplied cables have nice soft silicone sheath, but they are too thick to hand crimp into the connector housing.Erle Robotics (PXF, ErleBrain) supplied cables are thin, yet hard.3DR supplied ribbon cable are pretty good in terms of softness and durability.Shielded robot cables are OK, but since they are thicker and harder, they tend to pass on the vibrations from the other parts of the vehicle to the floating mounted FC, and sometimes even cause more resonant vibrations. Use of a regular PVC ribbon cable is not advised as they are prone to breakage. These connectors, along with the crimp terminals and crimp tools, can be purchased at RS-Online, Mouser, DigiKey, etc. However, Futaba uses different size pins and crimp terminals, so if you mix them, female connector may become loose.Futaba has extra tabs, but most FC's have a slit that enable you to insert Futaba connectors too.It also has locking tab, but are much larger than DF13 or GH connectors.CLICK-Mate connectors are also used on CAN bus based products.Pixhawk 2 (3DR version) and PixRacer beta (prototype) board used Molex CLICK-Mate.Used in such FC as CC3D, mini-sized Pixhawks such as Pixfalcon, Pixhawk Mini, etc.The crimping terminals are larger than DF13, so custom cables are a little easier to make.JST GH has a locking tab with click feedback, are not much larger compared to DF13, and insert direction is easy to identify.PixRacer (production version), PXFmini, and newer boards use JST GH Series Connector.This is what an I2C splitter with genuine Hirose DF13 looks like.They are usually not even genuine Molex Picoblade and are prone to cracking Most of the I2C splitters sold on Chinese sites are not DF13. If you insert DF13 into Picoblade headers, it will most likely break. Can be inserted into DF13 Female headers.
0 Comments
Leave a Reply. |